On Mon, Apr 16, 2012 at 5:20 PM, Oper.ML <email@example.com> wrote: > Hi guys,
> i have a SuperMicro server with an LSI SATA Controler with 16 hdd
> attached in RAID50.
> I would like to know wich operational system should i work with in
> this server? I will have 4 Xen host servers bringing up the DomUs in iSCSI
> with a dedicated gigabit network.
> I already had experience with the CenOS 5.5, running the TGTD daemon,
> e not pleasure one, cause the system keep staying with WAIT (I/O) reaching
> 100%, causing the DomUs to hang/freeze and remount the partitions in RO.
> I'm thinking about Ubuntu Server. Does anyone have sugestions and some
> experience to share about this?
I personally never use iSCSI anymore, but that said, I ran a private cloud
of KVM and Xen instances (65 or so dom0's) at a previous job while also
doing extensive research on silly ways to combine iSCSI volumes into huge
ZFS filesystems. Here is a quick list of stuff to consider:
* consider OpenSolaris ZFS + COMSTAR iSCSI or better yet, NFSv4 (Nexenta,
SmartOS, or OmniOS) for you storage machine, it's awesome
* use the Linux LIO iSCSI target stack! It's vastly superior to just about
all the others under duress
* it was really solid when I tested it a couple years ago (had about
400TB across 20+ systems)
* I also tested ietd, tgtd, COMSTAR, and a few others at that time
* if you can get two switches
* use Linux multipath instead of bonding if you can
* DO NOT bridge the switches (separate VLAN's & subnets)
* this is _really_ critical! You can lose an entire L2 network and keep
on going if you get this right
* Linux distribution is irrelevant, CentOS6 or Ubuntu LTS are both fine
* I'd go with 12.04 LTS if I was doing this today, build packages as
necessary if LIO isn't there
* use LVM instead of file backed volumes
* file backed volumes pretty much always stink, except under ietd where
it sucks exactly the same amount
* the iSCSI target machine should almost certainly be running the deadline
* disable Nagle's algorithm
* TCP buffers tuned much larger than the kernel defaults
* kernel is ideally compiled _without_ preemptive mode (most distros ship
* custom compiled kernels can make a difference in this setting!
* be prepared to install high-quality NIC's if your board didn't ship with
them (all the Supermicro boards I've tested had decent Intel NIC's, but I
was saddled with some Nforce boards at one point which were a disaster)
* enable large frames on the switch and all targets/initiators
* but don't set it to 9000 bytes like everybody does -s ome switches,
especially in the low-mid range screw up 9000 byte packets
* I usually err on the side of caution and page alignment and go with
around 8400 (easily fit 2 pages + headers, being exact doesn't buy you
anything but pain)
* never mix IO and VM traffic if you can help it
* by extension, don't let your IO traffic go over a bridge device
* bonded interfaces are OK if you can't use multipath
> Thanks alot.
> Tony M.
> Xen-users mailing list