What if it's a single server deployment? Can you configure some phones for multicast and others for unicast moh via MRGL? I'm not clear if a multicast stream fails to get to phone (due to MPLS network), will phone switch request to unicast somehow?
From: firstname.lastname@example.org [mailto:email@example.com] On Behalf Of Ryan Ratliff
Sent: Tuesday, September 28, 2010 4:56 PM
To: Mike Lydick
Subject: Re: [cisco-voip] MOH Multicast vs Unicast
Yes, the MOH server/source combo determines if unicast or multicast is used, and the server part comes from the device getting put on hold. Enable all of your audio sources for multicast and they can do both. Then it's just a matter of setting up the MRGLs so that HQ phones get a unicast MOH server and remote ones get a multicast server.
On Sep 28, 2010, at 4:04 PM, Mike Lydick wrote:
Is it possible design a blend Multicast environment where the HQ will use primarily unicast from the Software MOH and remote sites use Multicast from local route. I was thinking this was possible by enabling just 1 multicast server (to be used as the spoofed Local Router MOH multicast address) and all other servers are unicast. Limit the hop count to 2 and setup the local routers according (with the multicast config and single file for MOH).
cisco-voip mailing list
This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the
designated addressee(s) named above only. If you are not the
intended addressee, you are hereby notified that you have received
this communication in error and that any use or reproduction of
this email or its contents is strictly prohibited and may be
unlawful. If you have received this communication in error, please
notify us immediately by replying to this message and deleting it
from your computer. Thank you.